148
- This Document can not be used without Samsung's authorization -
. ADJUSTMENT
* If a lens is attached, the AE sensor can be seen more easily.
✁
The AE sensor has to be positioned as shown in the following figure without being shifted.
✂
Remove the adhesive which holds the AE sensor (0-J100).
✄
Loosen the screws and adjust the position of the AE senor (0-J100).
✄
Tighten the screws and check it again.
☎
After the adjustment, apply the adhesive to the two areas of the screws for the AE sensor (0-J100).
Center position of the AE sensor
Center position of the finder
Spot metering frame (Ø2.5)
AE sensor (0-J100)
Tolerance : 0.250.85 mm (actual dimension)
To Next Page
Loading...
