Section 2
Section 2
Placing And Receiving Calls 5554 Placing And Receiving Calls
Vibrate Mode
Turn the ringer off by opening your Jitterbug and pressing the volume button
on the outside of the phone until “Vibrate” appears on the Inside Display. Your
Jitterbug will be set to vibrate to alert you of incoming calls.
Adjusting The Ringer Volume
1.
2. Press the volume button on the upper left-hand side of the
phone. Press the top of the button to increase the volume and
the bottom of the button to decrease the volume.
The available options are:
Volume Button
The selected volume level will appear on the Inside Display.
The ringer can be silenced by pressing the volume button down until
“Vibrate” appears on the Inside Display. Your Jitterbug will now only
vibrate to alert you of incoming calls. This can come in handy at a movie,
a library or any other location where a ringer may be a distraction.
To Next Page
Loading...
Need help?
General
