Section 10
Section 10
Bluetooth 135134 Bluetooth
Setting Your Bluetooth Headset To Pairing Mode
Bluetooth device is called “Pairing.” This step
is required because there are no wires to link your Jitterbug to your Bluetooth
device. “Pairing” happens when your Jitterbug and your Bluetooth device agree
to communicate with one another. By “Pairing,” your Jitterbug recognizes your
Bluetooth device and the two devices automatically accept communication from
each other.
For step-by-step instructions on setting your Bluetooth headset to pairing mode,
please refer to the instruction guide found in your bluetooth headset packaging.
Please ensure you turn off your Bluetooth if you wish to receive calls
from your Jitterbug handset and not your Bluetooth headset. You are
unable to turn off your Bluetooth while on a call.
When your Bluetooth is on and available for
your use, you will notice a white Bluetooth
icon, similar to the one on the right, appear
at the top right corner of your Main Screen.
To Next Page
Loading...
Need help?
General
