43
Chapter 3. PC software (Multiple Display Control)
8 Select the All menu to check that the device has been registered.
9 When the device is approved by the server, the schedule registered in the
selected group will be downloaded to the device. The schedule will run after it is
downloaded.
•
user’s manual”.
• If a device is deleted from the list of devices approved by the server, the device
will reboot to reset its settings.
Setting the current time
A schedule may not run if the time set on the device is different from the server’s
current time.
1 Go to the tabs Device → Time.
2 Select your device.
3 Select Clock Set, and sync the time with the server.
using the GMT time of the region where the server is installed.
The time on the product can be changed from the server.
Turning the product off and then on again will restore the time setting on the
product to the last time that was set from the server.
• For further details on how to manage the time (scheduling, holiday
management, etc.), refer to the “MagicInfo Server user’s manual”.
To Next Page
Loading...
