Samsung M60 - Wireless Network (WLAN) Related

177
Q
How can I receive a FAX in Sleep mode (Standby
Mode)?
A ToreceiveaFAXwhenthecomputerisinSleep
Mode(StandbyMode),thecomputermustbe
conguredasfollows.
TheFAXprogrammustbeconguredsothatit
receivesFAXESautomaticallyreferringtotheFAX
programmanual.
 Click Start > Control Panel > Hardware and
Sound.
 Click on Phone and Modem Options.
 In the Modemtab,selectaninstalledmodem
andclickProperties.
InthePowerManagementtaboftheModem
Propertieswindow,selecttheAllow the
computer to turn off this device to save
power option and click the OKbutton.
(IfthePowerManagementtabdoesnot
appear,selectChangeSettingsintheGeneral
tab.)
Whenthemodemisconguredasabove,andaFAX
arrives,thecomputerwakesupfromSleepMode
andreceivestheFAX.
Q The <Wake On LAN> function
A1 <WakeOnLAN>isafunctionthatactivatesthe
system from Sleep mode when a signal (such as
apingormagicpacketcommand)arrivesoverthe
network(wiredLAN).
Using the <Wake On LAN> Function
 Click Start > Control Panel > Network and
Internet > Network and Sharing Center >
Manage Network Connections.
 Right-clickontheLocalAreaConnectionand
selectProperties.
 Click Congure > Power Management
tab.SelectAllow this device to bring the
computer out of standby,thenclickOK.
Restartthesystem.
—
 If the system is activated from Sleep mode when
thereisnoreceivedsignal,usethesystemafter
disablingthe<WakeOnLAN>function.
—
 Whenturningthepoweroffwhen<WakeOn
LAN>isdisabled,theLANLEDmaycontinueto
belit.
—
 ConnectingawiredLANwhileusingawireless
LANmaynotactivatethe<WakeOnLAN>
function.SettheWirelessLANtoDisable to use
the<WakeOnLAN>function.
Wired Network (LAN) Related