153
System
8
8 System
8.2 Multi Control
MENU [] System Multi Control ENTER
[ ]
Assign an individual ID to your product.
8.2.1 Configuring settings for Multi Control
z MDC Connection
Select a method to connect to MDC to receive the MDC signal.
RS232C MDC
Communicate with MDC via the RS232C-stereo cable.
RJ45 MDC
Communicate with MDC via the RJ45 cable.
z ID Setup
Assign an ID to a set. (Range: 0~99)
Press or to select a number, and press [ ].
z ID Input
Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
Refer to page 70 for details about the MDC menu.
m
To Next Page
Loading...
