177
System
8
8 System
z If you have selected an Anynet+ device by pressing the SOURCE button and then selecting
its input source, you cannot use the Anynet+ function. Make sure to switch to an Anynet+
device by using the Device List.
8.14.3 Receiver
You can listen to sound through a Receiver (i.e. Home Theater) instead of the product Speaker.
To listen to sound through a receiver, go to Receiver screen (System Anynet+ (HDMI-CEC)
Receiver). Then select Receiver and set to On.
If your Receiver supports audio only, it may not appear in the device list.
Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not work.
z Check if the device is an Anynet+ device. The Anynet+ system
supports Anynet+ devices only.
z You can connect only one receiver (home theater).
z Check if the Anynet+ device power cord is properly connected.
z Check the Anynet+ device’s Video/Audio/HDMI cable
connections.
z Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+
setup menu.
z Check whether the remote control is Anynet+ compatible.
z Anynet+ doesn’t work in certain situations. (Searching channels,
operating Plug & Play (initial setup), etc.)
z If you have removed and then reconnected the HDMI cable,
please make sure to search devices again or turn your product off
and on again.
z Check if the Anynet+ function of the Anynet device is set on.
I want to start Anynet+.
z Check if the Anynet+ device is properly connected to the product
and check if the Anynet+ (HDMI-CEC) is set to On in the
Anynet+ Setup menu.
z Press the TOOLS button to display the Anynet+ menu and select
a menu you want.
I want to exit Anynet+.
z Select View PC in the Anynet+ menu.
z Press the SOURCE button on the product remote control and
select a non- Anynet+ device.
To Next Page
Loading...
