Samsung ML-2150 - Connector Board

5-7
Samsung Electronics
Disassembly and Reassembly
Service Manual
5.8 Connector Board
1. Before you remove the Connector Board, you should
remove:
- RH Cover (Refer to the 5.5)
2. Unplug all of the connectors from the Connector
Board and take it out.
3. The connectors are located as shown below.
Connector
Board
MP Solenoid
Main Solenoid
Clutch
MP Empty
Control Board
5.9 Solenoid
1. Before you remove the Connector Board, you should
remove:
- RH Cover (Refer to the 5.5)
2. Unplug the MP Solenoid Harness and the Main
Solenoid Harness from the Connector Board.
3. Remove two screws and take out the MP
Solenoid.
4. Remove two screws and take out the Main
Solenoid.
NOTICE : It is not necessary to disassemble the
Main Drive Ass’y to remove the MP
Solenoid
MP Solenoid
Main Solenoid