Samsung ML-2150 - Toner Sensor Board

5-17
Samsung Electronics
Disassembly and Reassembly
Service Manual
5.20 Toner Sensor Board
1. Before you remove the Toner Sensor Board, you
should remove:
- Top Cover (Refer to the 5.13)
- LSU (Refer to the 5.19)
2. Unplug 4 Harness from the Toner Sensor Board.
3. Remove 4 screws and take out the Toner
Sensor Board.
4. Remove 3 screws and take out the LSU Lower
Cover.
LSU Lower Cover
HV Small
Spring
Toner Sensor Board