Samsung ML-2150 - Choosing Paper and Print Materials

6-2
ALIGNMENT & ADJUSTMENTS
Samsung Electronics
Service Manual
6.1.2 How to use EDC (Engine Diagnostic Control) Mode
Tray3 Interface
Interface Test
Pattern Print
Setting Temperature Test
Laser Diode Test
Laser Ready Test
Dev Bias Test
Charge Roll Voltage
Transfer Positive Voltage
Transfer Negative Voltage
PTL Test
Main Motor
Laser Motor
Duplex Forward
Duplex Reverse
Tray3 Motor
Fan Test
Tray1 Sensor
Tray2 Sensor
Tray3 Sensor
Duplex Sensor
Cover Open Sensor
Feed Sensor
Exit Sensor
Solenoid Test
Motor/Fan Test
Sensor TestHVPS Test
Development Test
Test Pattern Print
Tray1 Solenoid Test
Tray2 Solenoid Test
Tray3 Solenoid Test
Tray2 Clutch Test
Tray3 Clutch Test