EasyManua.ls Logo

Samsung MX-E850 - Party Function; Troubleshooting

Samsung MX-E850
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16 English English 16
English 17
Troubleshooting
Refer to the chart below when this unit does not function properly. If the problem you are experiencing
is not listed below or if the instruction below does not help, turn off the unit, disconnect the power
cord, and contact the nearest authorized dealer or Samsung Electronics Service Center.
Symptom Check/Remedy
I cannot eject the disc. •Isthepowercordpluggedsecurelyintotheoutlet?
•Turnoffthepowerandthenturnitbackon.
Playback does not start
immediately when the
Play/Pause button is pressed.
•Areyouusingadeformeddiscoradiscwithscratchesonthesurface?
•Wipethediscclean.
Sound is not produced. •Nosoundisheardduringfastplayback,slowplayback.
•Arethespeakersconnectedproperly?Isthespeakersetupcorrectly
customized?
•Isthediscseverelydamaged?
The remote control does not
work.
•Istheremotecontrolbeingoperatedwithinitsoperationrangeofangle
and distance?
•Arethebatteriesdrained?
•Theproductisnotworking.
(Example: The power goes out or
the front panel key doesn't work
or a strange noise is heard.)
•Theproductisnotworking
normally.
•While“NODISC”messageappearsonthedisplayoftheproduct,press
and hold the
STOP (@)
button on the main unit for longer than
5 seconds with no disc (reset function).
Using the RESET function will erase all stored settings.
Do not use this unless necessary.
Can't receive radio broadcast. •Istheantennaconnectedproperly?
•Iftheantenna'sinputsignalisweak,installanexternalFMantennainan
area with good reception.
Party function
You can choose a desired party mode.
1. Press the PARTY button.
Each time press this button, the party mode
will switch as following:
PARTY 1
;
PARTY 2
;
PARTY 3
;
DJ LIGHT
•
On the PARTY 2 and DJ LIGHTING mode, the Top LED will run depend on the signal level.(MX-E870/E871 only)
• On the PARTY 1 and PARTY 3 mode, the Top LED will be on or off and does not run. (MX-E870/E871 only)
• When you select the DJ LIGHT mode, if you tune the EASY SEARCHING JOG control, the LED Light of the
Speaker will flash.

Related product manuals