Samsung NX100 - Transfer Files to a Mac

Disconnect the camera from a PC
(Example: Windows XP)
Disconnect the camera from your PC. This step will
be similar when using Windows Vistal7.
1 Click on the tool bar at the bottom
right of your PC screen.
2 Click the pop-up message.
3 Click the message box indicating safely
removed.
4 Remove the USB cable.
, Ie' Do not remove the USB cable while data
~ is being transferred and the status lamp is
blinking. Wait until the' status lamp stops
blinking.
Transfer files to a Mac S p.106
~ The camera supports MacGS 10.4 or later.
1 Connect the camera to a Macintosh
computer with a USB cable.
If\. • Ensure the correct end of the cable is
L!J plugged into the camera. If the cable is
reversed, it may damage.your files. The.
manufacturer is not responsible for any loss
of data.
• If you try to plug the USB cable into the
HOMI port, the camera may not work
properly. If it occurs, restart the camera.
2 Turn on the camera.
3 When the pop-up appears on the camera
display, select Computer.
4 Open the removable disk.
5 Transfer files.
77
o
o
::J
::J
CD
()
.....
.....
o
Q.
~
0'
CD