16
PROGRAM TRUNK NAMES
This program is used to assign a character name or identification for each C.O. line.
You may assign a name of 11 characters long.
PROGRAM KEYS
UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
HOLD - Press to clear entry.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 404 [7
01] TRUNK NAME
Display shows
2. Dial trunk (e.g., 704) OR press UP or [7
04] TRUNK NAME
DOWN to select trunk and press the right
soft key to move the cursor
3. Enter the trunk name using the procedure [704] TRUNK NAME
in P
rogram Station Names and press the SAMSUNG
right soft key to return to step 2
4. Press TRSF to store and exit programming
OR press SPK to store and advance to
the next program
System_Administration_Guide.qxp 4/30/2007 12:56 PM Page 23
To Next Page
Loading...
