34
CUSTOMER SET RELOCATION
This program is used to swap information associated with two stations. All assign-
ments such as trunk ring,station group, station COS, station speed dial etc. will fol-
low this program. 18 button keysets and 28 button keysets can be exchanged. If
incompatible set types are selected the system will provide an ERROR: NO MATCH
message. 18 button and 28 button key assignments should be taken in consider-
ation when relocating these type of sets.The table below shows which phones can
be switched with each other.
NOTE: In order to use this program it must first be activated by a technician.Please
see your installing company to have this done if you wish to use this program.
PROGRAM KEYS
UP & DOWN - Used to scroll through options.
KEYPAD - Used to enter selections.
SOFT KEYS - Move cursor left and right.
SPK - Used to store data and advance to next program.
HOLD - Used to clear previous entry.
ANS/RLS - Used to select ALL.
ACTION DISPLAY
1. Press TRSF 315 SET RELOCATION
Display shows EXT _ EXT
2. Enter first station number (e.g., 202) SET RELOCATION
Press RIGHT soft key to move cursor EXT 202 EXT _
3. Enter second station number (e.g., 210) SET RELOCATION
Press RIGHT soft key to enter data EXT 202 EXT 2
10
4. Display will return to STEP 1 SET RELOCATION
Go to STEP 2 EXT _ EXT
OR press TRSF to store and exit
programming.
System_Administration_Guide.qxp 4/30/2007 12:56 PM Page 41
To Next Page
Loading...
