15
This PDP’s remote control can operate VCR, CATV , DVD, or
Set-top box (STB), in addition to controlling the PDP.
➢
The remote control is not compatible with the TV
manufactured by another company.
1 Turn off your VCR, Cable box, DVD or STB.
2 Press the SELECT button.
Mode is changed whenever
SELECT button is pressed.
3 Press the POWER () button on the remote control.
The component you select should turn on. If it turns on,
your remote control is now set correctly.
4 Once your remote control is set up, press the SELECT button any
time you want to use the remote control to operate your VCR,
Cable box, DVD or STB.
➢
When your remote control is in the VCR, CATV, DVD or
STB mode, the volume buttons still control your television’s
volume.
Setting Up Your Remote Control
➢
To program the cable receiver controls:
◆ Press the SELECT button to select CATV.
◆ Point the remote control at the cable receiver and press
the
SET button. Then press the company code number(s)
for the component in page 70.
Ex) If the component is manufactured by Oak, press 026.
➢
To program the VCR controls:
◆ Press the SELECT button to select VCR
◆ Point the remote control at the VCR and press the SET
button. Then press the company code number(s) for the
component in page 71.
➢
To program the DVD controls:
◆ Press the SELECT button to select DVD
◆ Point the remote control at the DVD and press the SET
button. Then press the company code number(s) for the
component in page 70.
ENG
VCR
BN68-00742A-00Eng_0621 2004.6.21 3:51 PM Page 15
To Next Page
Loading...
