English _25
LIVE
Switching to Single Mode
When in split mode, select and double-click a desired channel to switch to its Single mode.
Press the number corresponding to a desired channel the remote control to switch to its Single mode.
Refer to “Remote Control > Using the numeric buttons”. (Page 11)
Ex : If you click number 3 channel button or press the number 3 on the remote control.
SPOT OUT
The Spot Out monitoring is independent of the Live mode, which monitors a specific channel through the Spot Out
port.
Selecting a Spot Out mode
If an event occurs such as sensor, motion or alarm from the Spot Out port in connection with a monitor, you
can select a output screen mode.
1. In Live mode, right-click any area on the screen.
The Live menu appears.
2. Click <Spot Out>.
Supports the Spot output in Single screen with Auto
Sequence mode.
If the monitor is connected to the Spot port, the event that
occurred from the selected channel will be output on the
monitor.
For the Spot Out port of a model, refer to “Part Names and
Functions (Rear)”. (Page 10)
< Multichannel Live Menu >
To Next Page
Loading...
