32_
installing your camera
installing your camera
English English _ 33
INSTALLING YOUR CAMERA
FLUSH MOUNT TYPE INSTALLATION EXAMPLE
Drill Hole on the Ceiling
Attach the template, and then drill a hole according to the 120 mm diameter hole
marked on the template. Drop down the camera cables through the hole. Drill another
small hole for a screw to secure the camera.
Exiting Camera OSD
Rotate the dome cover counterclockwise to detach it from the camera.
1.
2.
Detach the Mount Housing
Remove the 3 screws, and then detach the mount housing from the camera.
Connect Cables & Camera Setup
Connect each camera cable to the proper terminals on the bottom of the camera (Refer
to Page 13: “Camera Wiring Interface Board”). Confi gure the DIP switches on the
bottom of the camera for communication and ID (Refer to Page 18).
3.
4.
To Next Page
Loading...
