Samsung SCP-2120 - Page 30

58_ functional description
functional description
English English _ 59
FUNCTIONAL DESCRIPTION
Tour SEQ
Main Menu/Sequence Setting/Tour SEQ
Selecting Tour SEQ recalls groups of preset locations
in a consecutive manner. Up to 6 groups can be
listed for this function.
Settings :
Selecting the Settings menu brings up the
following screen.
Using the joystick, you can enter desired group
numbers to the Group section. DWT indicates the
camera’s standby time before a new group is
recalled.
Execute :
Executes the group operation.
Clear :
Deletes the selected group.
►
•
•
•
Sequence Setting
Preset
Swing SEQ
Group SEQ
Tour SEQ
PTZ Trace
Auto Run
Power On Resume ON
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Password Setting
Status
Tour SEQ
Setting
Execute
Clear
Tour SEQ
NO Group DWT(s)
01 * 003
02 * 003
03 * 003
04 * 003
05 * 003
06 * 003
PTZ Trace
Main Menu/Sequence Setting/PTZ Trace
Maximum 4 patterns of the manual operation paths
(for Pan, Tilt, Zoom and Focus) are memorized and
replayed.
Replay :
Replays a route saved by the Trace function. Use
the Stop button to stop the replay.
Replay Once :
Replays a saved Trace route once.
Memorize :
Up to 120 seconds of a memory can be saved.
The memory duration varies depending on the
diffi culty level of the PTZ Trace action. As a trace is
saved, the remaining capacity of the memory card
is displayed. When the memory card is full, it turns
off with a message, "Mem. Left: 000%", on the
screen.
* Use the OSD On button to pause while saving a
trace. (When using the SCC-3100A/SCC-1000
controller)
* When Using Different Protocols
Protocol Product Memorize Pause
PELCO-D/P KBD300A Ack, Iris Open
SEC SCC-5000 OSD On, Iris Open
PANASONIC WV-CU161C OSD ON
VICON V1300X-DVC Iris Open
HONEYWELL HTX-3000 Iris Open
AD . OSD On, Iris Open
GE KTD-405 Iris Open
BOSCH . Iris Open
Clear :
Deletes a saved Trace route.
►
•
•
•
•
Sequence Setting
Preset
Swing SEQ
Group SEQ
Tour SEQ
PTZ Trace
Auto Run
Power On Resume ON
Main Menu
Camera Setting
Sequence Setting
P/T Setting
OSD Setting
Alarm Setting
Initialize
Password Setting
Status
PTZ Trace
Trace 1
Trace 2
Trace 3
Trace 4
PTZ Trace 1
Replay
Replay Once
Memorize
Clear