Motion detection
Events of motion detection can be set to trigger event signal output.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Event setup>.
3. Select <Motion detection> from
<Event action setup>.
4. Set whether or not to <Enable>.
5. Set <Sensitivity>, <Size> and <Area>.
6. Set whether to use <Detection result
overlay>.
When a motion is detected, its size and
position is marked with a rectangle on
the screen.
`
The opaque area near the bottom cannot be
set for the motion detection area.
7. Specify the activation time and
activation condition.
`
For more information about <Activation
time> and <Action>, refer to “Alarm input”.
(page 83)
8. When done, click [Apply (
)].
English _85
● SETUP SCREEN
To Next Page
Loading...
