Face detection
You can set to detect recognized face and trigger an event accordingly.
1. From the Setup menu, select the
<
Event ( )
>
tab.
2. Click <Event setup>.
3.
Select
<
Face detection
>
from <
Event
action setup
>
.
4.
Set whether or not to
<Enable>
.
5. Select <Sensitivity> tab to set the
sensitivity level.
`
As the sensitivity grows, face detection
becomes more close and detailed.
6. Select <Area> tab and drag on the
screen to define the desired detection
area. You can specify up to 4 detection
areas.
M
`
If the face on the screen is rotated more
than +, - 45°, the motion detection may
not recognize it.
`
If the screen is in mirroring mode, the
motion detection cannot operate properly.
In such cases, turn off the <Filp mode>
or <Mirror mode> in <Video setup>.
7. To delete a defined area, click [Clear] button while the Area tab is selected.
8. Set whether to use <Detection result overlay>.
When faces are detected, their positions and sizes are marked with rectangles on
the screen.
9. Specify the activation time and activation condition.
`
For more information about <Activation time> and <Action>, refer to “Alarm input”. (page 83)
10. When done, click [Apply (
)].
English _89
● SETUP SCREEN
To Next Page
Loading...
