setup screen
7. Specify an operation that will perform if an alarm occurs.
• FTP : Specify the use of FTP transfer in the alarm input setup.
• E-mail : Specify the use of email transfer in the alarm input setup.
• Record : Specify the use of recording in the alarm input setup.
• Alarm output : Select whether to set the alarm output if an alarm is incoming, and
specify the alarm output time.
• Goto preset : Moves to the specified preset location when setting the alarm input.
`
Only for SNB-5003/SNB-5004.
`
Only if the camera pan/tilt receiver is installed, Goto preset is available.
8. When done, click [Apply (
)].
Time schedule
You can set to save the video data at a certain interval as scheduled regardless of the
actual occurrence of the event.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <Event setup>.
3. Select <Time schedule> from <Event
action setup>.
4. Set whether or not to <Enable>.
5. Specify the <Transfer interval>.
6. Specify the activation time and
activation condition.
`
For more information about <Activation
time> and <Action>, refer to “Alarm input”.
(page 105)
J
`
The transfer interval setting value must be
smaller than the preset activation interval to succeed in image transmission.
7. When done, click [Apply (
)].
106_ setup screen
To Next Page
Loading...
