To set the video analysis rules
Passing
1. Set the type to <Passing, Entering/
Exiting>.
2. Set the event rule to <Virtual line
based rules>.
3. On the screen, click on preferred
starting and ending point of the virtual
line, then a popup window appears.
4. Select the desired rule:
• Right: Detects motions of moving
from the left to the right, over the
virtual line.
• Left: Detects motions of moving from
the right to the left, over the virtual line.
5. Click [OK].
6. To remove a defined rule, right click on the displayed virtual line to open popup
context menu and select [Delete] button.
Entering/Exiting
1. Set the type to <Passing, Entering/
Exiting>.
2. Set the event rule to <Defined area
based rules>.
3. On the screen, click four vertices to
define detection area and a popup
window appears.
4. Select the desired rule:
• Entering : Detects motions of moving
object whose center point entering
into the defined area, from outside of
the area.
• Exiting : Detects motions of moving object whose center point exiting from the
defined area, from inside of the area to outside.
5. Click [OK].
6. To remove a defined rule, right click on the displayed side lines of the area to open
popup context menu and select [Delete] button.
English _111
● SETUP SCREEN
To Next Page
Loading...
