setup screen
• Dwell time : This is the time while each applicable lighting condition is kept in
order to enable the switch between day and night modes.
• Duration : Specify the time interval of lighting at which the sequence operation is
triggered.
• Simple focus after D/N : When switching day/night mode, automatically runs
focus adjustment.
When using IR lens with the camera, set this to <Off>.
M
Setting <Simple focus after D/N> option may cause false focus adjustment under a specific
condition. For further details, refer to “Focus setup”. (Page 89)
• Sharpness mode : Adjust the overall sharpness of the image.
If selecting <On>, you can adjust the sharpness of the image.
• Sharpness level : The higher the level is, the sharper and clearer the outline of the
image becomes.
• Gamma : Adjust the contrast of the image.
• Color level : Adjust the color level of the image.
• Alarm in : Set the image to Color or B/W depending on the Open/Close state of
the alarm sensor.
If the Day & Night mode is set to Externel B/W, the alarm-in function of the event-alarm input page
will be disabled.
Special Setup (SND-7082/SND-7082F/SNV-7082)
1. Select <Special>.
2. Select each item and set it properly.
• Day & night : You can switch the
mode to adjust the black and white
level as well as the colors.
- Color : Always displays the video in
colors.
- B/W : Always displays the video in
black and white.
- Auto : Displays in color mode
during normal daytime and switches to black and white mode in a low contrast
scene at night.
If you set the AGC mode to <Off> from <Exposure>, the AUTO DAY/NIGHT mode will be
disabled accordingly.
- External B/W : Control the image modes of Color and B/W when an external IR
is synchronized via the Alarm In port.
86_ setup screen
To Next Page
Loading...
