QoS
You can specify the priority to secure a stable transfer rate for a specific IP.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <QoS>.
3. Click the [Add (
)] button.
The IP list will be created.
4. Enter an IP address to which you will
apply QoS.
M
The default prefix for IPv4 is 32;
For DSCP, the default is set to 63.
Only the IP addresses that are set to <Use> can be prioritized.
5. Select an IP to delete from the list.
Click the [Delete (
)] button.
6. When done, click [Apply ( )].
SNMP
With the SNMP protocols, the system or network admin can monitor the network devices
on a remote site, and configure the environment settings.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <SNMP>.
3. Specify the <SNMP>.
• Enable SNMP v1 : SNMP version 1
will be active.
• Enable SNMP v2c : SNMP version 2
will be active.
- Read community : Provide the
name of the read community where you can access to the SNMP information.
The default name is <public>.
-
Write community : Provide the name of the write community where you can
access to the SNMP information. The default name is <write>.
English _99
● SETUP SCREEN
To Next Page
Loading...
