802.1x
When connecting network, you can choose whether using 802.1x protocol, and then install
the certification.
1. From the Setup menu, select the
<Network (
)> tab.
2. Click <802.1x>.
3. Set the <IEEE 802.1x setting(EAPOL
using EAP-TLS)>.
• IEEE 802.1x : Specify the use of the
802.1x protocol.
• EAPOL version : Select version 1 or 2.
• ID : Enter the client certificate ID.
• Password : Enter the client private
key password. If the key file used is
not encrypted, you don’t need to enter it.
J
`
If the connected network device does not support the 802.1x protocol, the protocol will not
operate properly even if you set it.
4. Install/remove the certificate.
• CA certificates : Select a public certificate that contains the public key.
• Client certificate : Select a public certificate that contains the client certificate key.
• Client private Key : Select a public certificate that contains the client private key.
5. When done, click [Apply (
)].
To install/remove 802.1x related certificates
1. Press the [Browse ( )] button for each item and select a certificate to install.
2. If no certificate is installed, you will see “Not Available” appearing next to the selected
item.
3. Press the [Install (
)] button to start installation with a message of “Installed”
next to the item.
4. Press the [Delete (
)] button to remove the certificate.
setup screen
108_ setup screen
To Next Page
Loading...
