Face detection
You can set to detect recognized face and trigger an event accordingly.
1. From the Setup menu, select the
<
Event ( )
>
tab.
2. Click <Face detection>.
3.
Set whether or not to
<Enable>
.
4. Select <Sensitivity> tab to set the
sensitivity level.
`
As the sensitivity grows, face detection
becomes more close and detailed.
5. Select the <Area> tab and select 4
vertices in the image with your mouse
to specify the detection area.
`
Select up to 4 areas for detection or non-
detection.
`
While drawing the area, you can cancel an
area by right-clicking.
6. To delete an area, right-click on the
area, and select delete [OK] on the
pop-up menus.
7. Specify the activation time and
activation condition.
`
For more information about <Activation
time> and <Action>, refer to “Alarm input”. (page 122)
8. When done, click [Apply (
)].
setup screen
132_ setup screen
To Next Page
Loading...
