MD / VA
Events of motion detection and video analysis can be set to trigger event signal output.
1. From the Setup menu, select the
<Event (
)> tab.
2. Click <MD / VA>.
3. Specify the usage type.
4. Set whether or not to <Enable>.
J
`
DIS cannot be used if Motion detection/
Video analytics is used.
5. According to your purpose, select from
motion detection and intelligent video
analysis.
6. Set <Sensitivity>, <Size> and <Area>.
When selected Intelligent Video
Analysis, set <Analytics> too.
7. Specify the activation time and
activation condition.
`
For more information about <Activation
time> and <Action>, refer to “Alarm input”.
(page 122)
8. When done, click [Apply (
)].
setup screen
126_ setup screen
To Next Page
Loading...
