setup screen
128_ setup screen
To use the Intelligent Video Analysis (VA) function
1. Select the <Video analytics> mode.
2. Select the sensitivity of separating
movement from the background.
You can select 5 levels of sensitivity (very
low/low/normal/high/very high).
3. Select the size of the object for
observation.
• Minimum size (pixel) : To restrict the
minimum movement to be observed,
select <Minimum size (pixel)> and
enter the width and height. The unit
is pixel, and you can select any value
equivalent to or higher than 32 x 32.
• Maximum size (pixel) : To restrict the
maximum movement to be observed,
select <Maximum size (pixel)> and
enter the width and height. The unit
is pixels, and you can select any
value up to 1280x1024.
J
`
Motions smaller than the specified
minimum size or bigger than the
maximum size are not detected. To avoid
unintended detections caused by great
and small noises, set minimum/maximum
motion sizes appropriately in accordance to your environments.
`
Note that same motions on the same location can be differently detected in their detection size;
it is recommended to consider and include the tolerable difference when setting the minimum/
maximum detection sizes.
To Next Page
Loading...
