Samsung SNP-L5233H - Page 130

To set the video analysis rules
`
Passing
1. Set the type to <Passing>.
2. Click the start and end point on the
screen to set the base line.
You can cancel the line while drawing
an area by right-clicking the mouse.
3. Select the desired rule:
• Right: Detects motions of moving
from the left to the right, over the
virtual line.
• Left: Detects motions of moving from the right to the left, over the virtual line.
4. Click [OK].
5. To remove a defined rule, right click on the displayed virtual line to open popup
context menu and select [Delete] button.
`
Entering/Exiting
1. Set the type to <Entering/Exiting>.
2. Click 4 points on the screen to set the
base area.
You can cancel the line while drawing
an area by right-clicking the mouse.
3. Select the desired rule:
• Entering : Detects motions of moving
object whose center point entering
into the defined area, from outside of
the area.
• Exiting : Detects motions of moving object whose center point exiting from the
defined area, from inside of the area to outside.
4. Click [OK].
5. To remove a defined rule, right click on the displayed side lines of the area to open
popup context menu and select [Delete] button.
setup screen
130_ setup screen