English _23
● INSTALLATION & CONNECTION
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
` Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
` The heater will operate properly only by the power source of AC 24V.
` If using PoE, the heater will not operate at all.
Use an adaptor if the installation site requires heater operations. Adaptor is sold separately.
For the power specifications, refer to the “Appendix”. (page 96)
` If PoE and DC 12V are both applied, this camera will get supplied with power from PoE.
` Please make sure the monitor and camera are turned off when connecting them.
To Next Page
Loading...
