70_ using the DVR
using the DVR
Recipient Setting
You can add/remove a recipient(s) to/from the specified group and edit the group if necessary.
Using the mouse may help make setup easier.
1. In the <Network> setting window, press the up/down
(
) button to move to <Mailing Service> and press the
[ENTER] button.
2. Select <Recipient>.
3. Use direction buttons (
◄ ►
) to move to a desired item
and set the value.
• Add : You can select a recipient name, e-mail address or
group.
You should have created a group in the <Group> menu
item before you can add a user to the group.
For inputting the recipient name and email address, refer to
“Using Virtual Keyboard”. (Page 40)
4. When the recipient setting is done, press <OK>.
SNMP
You can configure the settings for the SNMP protocol.
Using the mouse may help make setup easier.
1. From the <Network> setup window, use the
buttons
to move to <SNMP>. Then, press [ENTER].
The SNMP setup screen appears.
2. Use the four direction buttons (
◄ ►
) to move to a
desired item. Make your settings as necessary.
• Enable SNMP v1: SNMP version 1 will be active.
• Enable SNMP v2c: SNMP version 2 will be active.
- Read Community : Read community where you can
access objects that support the SNMP protocols.
- Write Community : Write community where you can
access objects that support the SNMP protocols.
3. When completing the SNMP settings, click <OK>.
Mailing Service
SMTP
OK Cancel
Event Group
Recipient
Group Name e-Mail Address Delete
Add
Group All Group
Previous/Next Page
Mailing Service
SMTP
OK Cancel
Event Group
Recipient
Group Name e-Mail Address Delete
Add
Group ABC
Previous/Next Page
Add recipient
OK Cancel
Name
Email
Select Group ABC
SNMP
OK Cancel
Enable SNMP v1
Enable SNMP v2c
Read Community public
Write Community write
To Next Page
Loading...
