English _49
! USING THE DVR
Setting the Spot Out
You can set the DVR to output information / video apart from the monitor out.
Using the mouse may help make setup easier.
Use the up/down buttons (
▲▼
) in <Device> window to
move to <Monitor>, and press [ENTER] button.
Select <Spot Out>.
The number of Spot Out terminals differs according to the
model.
Use direction buttons (
▲▼_ +
) to move to a desired
item, and set the value.
Spot Out 1 : You can select between Auto Sequence, and
Single.
Set Mode : A window for “Set Spot Out” appears and you
can set the channel for it.
You can set the dwell time between the screen switching in
“Setting the Device > Camera > SEQ-Dwell Time”.
(Page 42)
You can setup using the mouse right button in Live screen.
Refer to “Spot Out”. (Page 29)
When the Spot Out is done, press <OK>.
Setting the Screen Mode
You can configure the Live screen and Split Screens.
Using the mouse may help make setup easier.
Use the up/down buttons (
▲▼
) in <Device> window to
move to <Monitor>, and press [ENTER] button.
Select <Mode>.
Use direction buttons (
▲▼_ +
) to move to a desired
item, and set the value.
Live Screen : Select split modes for the Live screen.
4-split screens are included by default.
Play Screen : Select split modes for the playback screen.
Single screen and 4-split screen are provided by default.
When the screen mode setup is done, press <OK>.
3.
4.
`
5.
~
~
M
`
6.
3.
4.
5.
~
~
6.
Monitor
Spot Out
Monitor
Spot Out 1 SEQ
Mode
OK Cancel
Set Mode All
Monitor
Mode
Monitor Spot Out
OK Cancel
Live Play
Live Screen
Play Screen
Monitor
Spot Out
Monitor
Spot Out 1 4-split
Mode
OK Cancel
Set Mode
Set Spot Out
OK
1 2 3 4
To Next Page
Loading...
