English _5
GETTING STARTED
If you start the product, the <Install Wizard> screen will appear.
Follow the <Install Wizard> to set the product in an easy way and automatically register your camera.
M
` Before you start the product, you must connect the product to a hard disk drive, NVR, and network camera. (see pages
19~33 of the User Manual)
` At the time of initial registration, leave the camera in the initial setting.
Install Wizard
As shown below, proceed through each step of the <Install Wizard>.
1. In the <Language> screen, select the language and press the <Next> button.
2. In the <ID/PW> screen, set the password and press <Next>.
M
` If you click < >, a basic guide for password setup is displayed.
3. In the <Network> screen, set the network access method and the access environment. To use a simple
intranet, click <Next>.
• Network 1 (Camera
) : Connects to the camera and receives the video feed from the camera
• Network
2 (Viewer) : This is a port for transmitting an image to the webviewer.
• Network 1 / Network
2 Setup
- IP Type : Choose the network connection method.
- IP Address, Subnet Mask, Gateway, DNS
M
`
If the LAN cable is not connected to the port, the setting button will not be activated for use. Check the LAN cable connection.
` The built-in DHCP Server in NVR will turn on automatically at stage 3. At this stage, using the existing DHCP server in the
same network may cause a problem, as two DHCP servers would be simultaneously operating.
` For more details on network settings, refer to the user manual.
4. After setting the date/time settings in the <Date/Time> screen, click on the <Finish> button to launch the
setting completion window.
5. In the setting completion window, click on the <OK> button to finish camera setting and launch the camera
registration screen.
To Next Page
Loading...
