Samsung WA45M3100AW/A4 - Page 24

22 _ Troubleshooting
Code Type Code Mode Causes Corrective Actions Description of Photo
Water Supply Code
►ExtraHigh LED Flash
This may occur when the water supply valve is defective.
• If the water supply valve is broken, replace
the valve.
• Check if the water supply is blocked due
to an alien substance in the valve or check if the water is supplied to the machine. If a problem is found, take the appropriate countermeasure.
• Check if the water supply is blocked due to
the water being frozen.
• If the PBA Relay malfunctions, replace the
PBA.
1. Measure the resistance of the
water supply valve.
- Resistance:0.9KΩto1.1KΩ
between the terminals of the Water Supply Valve.
2. Check whether there is foreign
material in the Water supply valvelter.
►Hot&Low LED Flash
This may occur when the main PCB is defective. This may occur due to frozen water.
Drain Code
►LowLED Flash
This may occur when the drain pump is defective.
• Check if there is any alien substance inside
the draining pump motor.
• Check the natural drain in the same manner. • Check if there are any incorrect connections
or broken wires.
• If the machine malfunctions intermittently
when the wash tub water temperature is high, replace the pump.
• If the motor stops due to the water being
frozen in winter, remove the frozen water referring to the relevant repair procedures.
Check the drain pump resistance. (Resistance:13.5~16.5Ω)
This may occur due to frozen water. Check if there is any alien substance inside the draining pump. This may occur when the main PCB is defective.
Communication Code
►WarmLED Flash
The signals between the sub and main PBAs are not sensed.
• Check the wire connections and terminal
contacts between the sub and main PBAs.
• Check for disconnected wires. • Check whether the sub PBA is short-circuited
because of moisture.
• If the main PBA’s communication circuit is
faulty, replace it.
-
Incorrect wire connections between the sub and main PBAs.