Samsung WA45M3100AW/A4 - Page 25

Troubleshooting _ 23
Symptom Check Code Countermeasure Troubleshooting Procedure Measurement Picture
Water Leakage Code
►HighLED Flash
This may occur when an alien substance is in the DV Case.
• Since this occurs when an alien substance is
in the Draining Bellows, for natural draining, remove the alien substance.
• If the drain motor is defective, replace the
motor.
• Check if the water leaks from the tub
connection part.
Check if there is any alien substance in the Draining Bellows.
Check if there is any alien substance such as underwear wire, coins, etc.
This may occur due to a defect of the product’s internal hose or from the part assembly.
Unbalance Code
►Hot&Warm LED Flash
This may occur due to the laundry being unevenly distributed.
• Check the laundry type and check if the
laundry load is unbalanced.
- Make sure to check if there is any laundry
present that absorbs a lot of water even if itsvolumeisLowandexplaintheproblem comprehensively, if necessary.
-
Mems PBA Detected
►Hot&Tap Eco Warm LED Flash
This may occur due to disconnection.
• Check wire connections.
This may occur when the Mems PBA is defective.
• Replace the Mems PBA. • Replace Mems PBA because of the main
PBA wire disconnection Code or PBA silver nano part malfunction.
OverowCode
►MidLED Flash
This may occur when the
water level sensor is defective.
This may occur when water
is supplied continuously due to freezing or foreign materials in the water supply valve.
• The water level sensor is replaced.