26 _Disassembly and Reassembly
No. Part name Description Figure
10 Removing
the Duct
(Replacing
the Dry
Motor)
3. Remove the screws.
√Check the following 2 points for troubleshooting
1. Revolve the dry motor manually and check whether spin the dry
motor manually and check that it rotates freely.
2. Measure the internal resistance (between the white and blue wire
terminals)
→ several Ω: short-circuited, ∞: disconnected.
10 Removing
the Duct
(THERMO-
STAT)
1.Remove the connector.
Remove the jacks connect-
ed to the thermostat and
remove the four (4) screws,
as show in the gure.
√Check Points for Troubleshooting
● Measure the resistance between both ends of the thermostat: 0 Ω
→ If the studio is raised due to overheating and it is pressed, it will be
returned to the original position with a ‘snapping’ sound.
10 Removing
the Duct
(THERMIS-
TOR)
1. Remove the 2 screws
connected to the dry duct
and remove the white
thermistor.
To Next Page
Loading...
