Samsung WD106UHSA SERIES - Corrective Actions for Error Codes

Troubleshooting _ 41
4-2. CORRECTIVE ACTIONS FOR EACH ERROR CODE
► Thesearecommontroubleshootingproceduresforeachdrum-typewashererrormode.Fordetailedinformation,refertothegeneralrepairscripts.
Error Type Error Mode Causes Corrective Actions Description of Photo
WaterLevel Sensor
1E
• Waterlevelsensorfault • Incorrectconnectionsofthewater
levelsensorterminal
• Thehosepartforthewaterlevel
sensorisfolded.
• MainPCBfault
• Checkthewaterlevelsensorterminal
connectionsandcontacts.
• Anerroroccursifanincorrectwaterlevel
sensorisused.Makesuretocheckthe materialcode.(Abnormaloperation)
• Ifthewaterlevelsensorisfaulty,replaceit. • Iftheerrorpersistsdespitetakingtheaction
above,replacethePBA.
Checkthewaterlevelsensor frequency. - Checkitafterthewaterlevel
sensorandtheconnector areconnected.
- Frequency:Approx.26.4
KHzwithnoload
WashingMotor ErrorandHall SensorError
3E
3E1 3E2 3E3 3E4
• Washingmotorfault • Washingmotorhallsensorfault • Incorrectconnectionsofthe
washingmotor/hallsensor connector
• Washingmotorrotorandstator
fault
• MainPCBfault
• Checkthemotorconnectorterminal
connectionsandcontacts.
• 3E1isdisplayedbecauseoverloadingoccurs
duetotoomuchlaundry.
• Ifthehallsensorterminalisfaulty,replacethe
hallsensor.
• Checkwhetherthestatorofthemotorcoveris
damaged.
• Checkforcoildisconnectionsduetoforeign
material.
• IfthePBAcontrolcircuitisfaulty,replacethe
PBA.
► DDMOTOR Checktheresistanceonthe mainPCBmotor.(Betweenpins 1and3,and1and4ofthefour (4)pins) - Resistance:Approx.2to4
MΩ
- Checkthevoltagewhenthe
powerison.
► UNIVERSALMOTOR ChecktheResistanceofNos.1 and4ofthewirepinontheside oftheTACHOSENSOR. - Resistance:Approximately
40to45Ω(Normal)
► THREEPHASEMOTOR MeasuretheResistanceofNos. 2and3ofthewirepinonthe sideoftheHALLSENSOR. - Therevolutionofthedrum
needstobereproduced. (Turnthedrumbyhand.)
- Resistance:Approximately3
to12V(Voltagesmaydiffer dependingonthespeedof therevolutions.)