EasyManua.ls Logo

Samsung WF42H5200A - Installer Notes and Steps; Removing Shipping Bolts

Samsung WF42H5200A
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ALIGNMENT AND ADJUSTMENTS
15
Smart Install Mode
Denition of Smart Install Mode:
- SmartInstallModeisthemodethatconrmwhether
normalsetmodeendsaftersettinghasbeendone.
How to Enter:
- Understandbycondition,Settheappointmenttime
to17:00.IfyoupushStart/Pausebuttonfor7seconds,
youwillenterSmartInstallMode.
Samrt Install Mode
- WhenenteringSmartInstallMode,itwilldisplay“SC”.
- SmartInstallModehastwoModes
ManualMode:WhenyoupushDelayEndbutton,
submodewillbeadded.
AutomaticMode:Undertheconditionof“SC”or“OK”
beingdisplayed,ifyoupushStart/Pausebutton,itwillchangetoautomatic
modetilltheendofinspection.
- ThedisplayandTestofvarioussubmodesareasfollows:
SC:standbycodition
1:DoorLockTest
2:DrainPumpTest1
3:PreValveTest
Co:ColdValveTest
Ho:HotValveTest
6:WatershotValve&MotorTumble&WaterHeaterTest
7:DrainPumpTest2
8:SpinTest
9:DryHeater&DryFanTest
10:DoorUnlockTest
Ot(OK):Normalend
- Ifyoupush“DelayEnd+Start”simultaneouslywhendisplaying”SC”,EEPROMwillbereadand
OKornGwilldisplay.
- Ot(OK):SmartInstallendsnormally.
nG:SmartInstallendsabnormallyordoesn’texecute.
Standby Condition
Set the appointment time to 17:00
Push Start/Pause button for
7 seconds
Smart Install Mode
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
(Techsheet)WF42H5-03387A_EN.indd 15 2013-12-24 17:12:49

Other manuals for Samsung WF42H5200A

Related product manuals