Samsung WF42H5200A - Quick Spin Test Mode

ALIGNMENT AND ADJUSTMENTS
9
Quick Spin Test Mode
Denition of Quick Spin Test Mode:
- QuickSpinTestModeistodoSpinCheck.(HighRPM)
How to Enter:
- DuringServiceMode,presstheDelayEndandTempKeysfor3secondstoenterQuickSpinTestMode.
- Cannotenteroncethewashingcyclehasstarted.
Quick Spin Test Mode:
AsitentersintotheQuickSpinTestMode,itstartsspinningandreachestoitsmaximumRPM.
OncetheSpinspeedreachesthemaximumRPM,thespeeddropsimmediately.
ToholdQuickSpinTestMode(enteringHoldSpeedMode),presstheStart/Pausebutton.Ifthe
Start/PausebuttonispressedduringQuickSpinTestMode,itwillstopacceleratingandholdits
spinningspeedfor10minutesbeforegoingbacktoQuickSpinTestMode.
Also,tocanceltheholdandallowQuickSpinTestModetocontinue,presstheDelayEndandTemp
Keysfor3secondsIfyoutheDelayEndandTempKeysfor3secondswhenthewashingmachineis
notinHoldSpeedMode,QuickSpinModeisexitedandServiceModeisrestored.
Toavoidriskofelectricalshock,personalinjuryordeath;disconnectpowertowasher
beforeservicing,unlesstestingrequirespower.
WARNING
Delay End + Temp for 3sec or after 10 minutes
3 sec
While a cycle is not running
While it is not in Hold Speed Mode
Service Mode
Start/PauseQuick Spin Test Mode
Hold Speed Mode
Delay End + Temp Delay End + Temp
(Techsheet)WF42H5-03387A_EN.indd 9 2013-12-24 17:12:47