ALIGNMENT AND ADJUSTMENTS
5
Quick Test Mode
Model: WF455AR*
Model: WF457AR*
Denition of Quick Test Mode:
- Check operation of all LED’s (Verify faulty LED).
- Check model and software version.
- Check dierent operating modes (e.g. water valve, motor, door, drain pump, etc.).
How to Enter:
Model : WF455AR*
- Plug in the unit.
- Press Soil Key, Spin Key and Power Key at the same Time.
Model : WF457AR*
- Press Start button and Power button at the same Time for 1 second or less.
(factory mode over 1 second pressing)
- If ‘02’ or ‘01’ are displayed, machine entered factory mode. Turn o the machine and try again.
✻Before entering QuickTest Mode, turn on AP.(WiFi AP)
After entering QuickTestMode, WiFi testing is done automatically.
If there is “AE4” error check WiFi module in LCD Module.
✻Press the Start button after the AE3 or AE4 error occurs to cancel the error notication and
continue quick test mode.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
(Techsheet)WF457AR-03152A_EN_20120404.indd 5 2012-04-04 �� 12:12:26
To Next Page
Loading...
Need help?
General