Wired network setup | 37
Activating IPv6
1 Access a web browser, such as Internet Explorer, from Windows. Enter the machine IP
address (http://xxx.xxx.xxx.xxx) in the address field and press the Enter key or click Go.
2 If it’s your first time logging into SyncThru™ Web Service you need to log-in as an
administrator. Type in default ID (admin). Default password is sec00000. We recommend
you to set the default password for security reasons. You can change your ID and password
from Security > System Security > System Administrator.
3 When the SyncThru™ Web Service window opens, move the mouse cursor over the Settings
of the top menu bar and then click Network Settings.
4 Click TCP/IPv6 on the left pane of the website.
5 Check the IPv6 Protocol check box to activate IPv6.
6 Click the Apply button.
7 Turn the machine off and turn it on again.
• You can also set the DHCPv6.
• To manually set the IPv6 address:
Check the Manual Address check box. Then, the Address/Prefix text box is
activated. Enter the rest of the address (e.g.,:3FFE:10:88:194::AAAA. “A” is the
hexadecimal 0 through 9, A through F).
To Next Page
Loading...
