Introduction
S&C Instruction Sheet 1045-511 3
Replacement parts provided by the seller or repairs performed by the seller
under the warranty for the original equipment will be covered by the above special
warranty provision for its duration. Replacement parts purchased separately will
be covered by the above special warranty provision.
For equipment/services packages, the seller warrants for a period of one year
after commissioning that the 6800 Series Automatic Switch Control will provide
automatic fault isolation and system reconfiguration per agreed-upon service
levels. The remedy shall be additional system analysis and reconfiguration of the
IntelliTeam SG Automatic Restoration System until the desired result is achieved.
Warranty of the 6800 Series Automatic Switch Control is contingent upon the
installation, configuration, and use of the control or software in accordance with
S&C’s applicable instruction sheets.
This warranty does not apply to major components not manufactured by S&C,
such as batteries and communication devices. However, S&C will assign to the
immediate purchaser or end user all manufacturer’s warranties that apply to such
major components.
Warranty of equipment/services packages is contingent upon receipt of adequate
information on the user’s distribution system, sufficiently detailed to prepare a
technical analysis. The seller is not liable if an act of nature or parties beyond
S&C’s control negatively impact performance of equipment/services packages; for
example, new construction that impedes radio communication, or changes to the
distribution system that impact protection systems, available fault currents, or
system-loading characteristics.
To Next Page
Loading...
Need help?
General
