S&C 6800 Series Navigation Guide

Safety Precautions
DANGER
The 6800 Series Automatic Switch Control line voltage input range is 93 to
276 Vac. Failure to observe the precautions below will result in serious
personal injury or death.
Some of these precautions may differ from your company’s operating procedures
and rules. Where a discrepancy exists, follow your company’s operating procedures
and rules.
1. QUALIFIED PERSONS. Access to the 6800 Series
Automatic Switch Control must be restricted only to
qualified persons. See the “Qualified Persons”
section on page 2.
2. SAFETY PROCEDURES. Always follow safe
operating procedures and rules.
3. PERSONAL PROTECTIVE EQUIPMENT. Always
use suitable protective equipment, such as rubber
gloves, rubber mats, hard hats, safety glasses, and
flash clothing, in accordance with safe operating
procedures and rules.
4. SAFETY LABELS. Do not remove or obscure any
of the “DANGER,” “WARNING,” “CAUTION,” or
“NOTICE” labels.
5. MAINTAINING PROPER CLEARANCE. Always
maintain proper clearance from energized
components.
S&C Instruction Sheet 1045-511 5

S&C 6800 Series Specifications

General

Brand	S&C
Model	6800 Series
Category	Controller
Language	English