TPMS1209C01 User Manual
Page 16 of 23
Pressure Unit Programming
Under the pressure unit inquiry interface, press E key for 3 seconds to enter
the programming interface. The system current unit flashes. As shown in left
figure.
Press S key to switch the pressure unit among the psi, bar and kpa.
The current selected unit is KPa and it will flash. Press E key for 3 seconds
to save the selected unit with beep buzzes twice and screen flashes twice,
and then system return to pressure unit inquiry interface.
During programming process, Press S key for few seconds can return to the
index interface 3, no change will be saved to the system.
Temperature Unit Programming
Under the temperature inquiry interface, press E key for 3 seconds to enter
the programming interface. The current unit will flash.
Press S key to switch the temperature units between ℃ and ℉.
The current temperature unit is ℃, the unit flashes continually. Press E key
for 3 seconds to save the selected unit with two beeps and the screen
flashes twice, then returns to the temperature unit inquiry interface.
To Next Page
Loading...
Need help?
General