Sansui SR-636 - Setup and Connections; Removing Shipping Screws and Packing; Turntable and Weight Mounting

10
Setting-up and connections
This turntable is a precision instrument. To protect the delicate parts
inside during shipment they are secured in place by shipping screws, or
packaged separately. Remove, set up and connect these parts as
follows:
‘Remo
With a screwdriver, remove the two shipping screws together with the
red cardboards. Keep them for possible future use; re-ship the unit only
after re-securing the parts as originally shipped.
onto the motor spindle, taking care not to apply any unreasonable force
to the spindle. When the platter is securely fitted, place the rubber mat
on it.
Removing the protective packing -
To remove the packing used for tonearm protection, pull them toward
the direction indicated by the arrows, as shown in the illustration.
Mounting main weight =
Fit the main weight on the weight shaft of the tonearm and pull it
toward you while turning it gently to the right.