Sansui SR-636 - Installation and Connections; Arm Height and Headshell Adjustment; Dust Cover and Amplifier Connection; 45 RPM Record Adaptor

18
(
45 rpm record adaptor
Adaptateur de disque a 45 t/mn
Adapter fiir 45 er Schaliplatten
Armheight adjustment
If
you
replace
the
cartridge
supplied
with
another,
adjust
the
tonearm
height, if necessary , so that the arm is horizontal when playing a (ecard,
To adjust, /oosen the two screws, shown in the iffustration with arrows,
with the hexagonal wrench supplied.
The headshell supplied has provisions for left/right tilt adjustment to
keep the headshell strictly horizontal. Normally headshell adjustment
is not needed, for it’s undertaken at our factory prior to shipment. In
case you want to undertake the adjustment, loosen the screw (—), move
the headshell to the left or right to bring it into balance, then retighten
the screw.
Mounting
dust
cover
re
Dust cover is mounted by inserting dust cover fittings into openings on
the rear wall surface of the cabinet. When the dust cover is to be dis-
mounted, it should be fully opened and pulled directly upwards,
Connect
the
pin-plug
cables
of
the
unit
to
the
PHONO
terminals
on
your
amplifier.
The
red
pin
plug
should
be
used
for
the
right
channel,
the
white
pin
plug
for
the
left.
The
vinyl
covered
cable
without
a
pin
plug
is
for
grounding.
Connect
it
to
the
GND
terminal
on
your
amplifier.
Take
care
not
to
lose
the
supplied
45
rpm
(EP)
record
adaptor
when
not
in use.