Sansui SR-636 - Replacement, Lubrication, and Power; Stylus Replacement; Lubrication Guidelines; Power Voltage Setting

26
_ Replacement of styli D
A diamond-tipped stylus will asually provide about 500 to 800 hours ei
high fidelity record playback.
A worn stylus, however, will cause distorted or crackling sound repro-
duction. You are advised to replace your stylus as frequently as possible.
A replacement stylus is available from the nearest Authorized Sansui
Service Station or from the Sansui dealer from whom you have pur-
chased your turntable. Be sure to specify the model ‘‘SN-43” Sansui
replacement stylus.
Lubrication
Your unit requires no lobreatiol viihalsoaven: Nats shat apollcation at
oil to the unit's platter shaft or platter bearing may cause turntable
breakdown.
Power voltage
Your turntable is adjusted in our factory: t to aperete on the power
voltage of the area where you purchased it. Therefore, should you move
to an area where the voltage is different from the factory-adjusted one,
you have to make the voltage changeover. Make the changeover refer-
ring to the attached voltage/frequency changeover sheet.
If, however, the area where you bought your turntable is one where
users are prohibited from making such changeover, changeover is not
possible. In other areas, consult with your nearest electric appliance
dealer about the specific voltage adjustor you need.