Sansui SR-636 - Operating the Turntable; Cautions Before Playing Records; Starting and Stopping Playback

20
33
45
4
33
a) ieee BE eee
33
45
45
4
33
33
45
45
Operation
*
/ Cautions prior to record play
Starting playback _
Check that tracking-force, skating-force and ether adjustment have
been properly made.
Pay special attention when handling the turntable and your records.
Rough handling may result not only jn shortened life of the turn-
table but also in severe record damage.
Never attempt to halt platter rotation by hand, operate the power
button and wait until the platter coasts to a stop.
Place a record of your choice on “the mere and pen te: POWER
switch.
. Push either the 33rpm or 45 rpm speed select button depending on
the speed of the record you are about to play.
Should both buttons be pushed or protruded, the selected speed will
be as shown in the illustration. Then push the correct button again
to have the correct speed.
. Remove the tonearm from its rest and move it so that the stylus is
directly above the selection on the record you wish to hear.
. Pull the arm lifter lever to the W side gently toward you, Then the
tonearm will gently descend to the record and play begins.
. Adjust controls on your amplifier to the desired volume and tone
quality.
Push the arm lifter lever to the V side, return the tonearm to the arm
rest and push the POWER switch again (Power off).