A2 Automatic Dispenser V3.0 11
according to the dispensing software reminders.
No need to add water to the dry brush container. Add some water to the wet brush container (Do not
exceed the cleaning wheel shaft). The clean shall be done by following manners to ensure the cleaning
effects.
Detailed steps as below：
1) Open the side door of the left front of the dispenser then turn the lock handle clockwise to loose the
cleaning box;
2) Pull the cleaning box out;
3) You may clean the brush wheel and the cleaning box separately. Rotate the wet brush for a better
clean of the cleaning box. Clean each valve bottom thoroughly.
4) Put the cleaning box back and push down lock handle. Lock the side door.
To Next Page
Loading...
