98127 EN 2.2 - 12 2010 7 / 19 www.santos.fr
SANTOS : Instruction and maintenance manual
(whisking), those in the middle for medium speeds (work with the paddle), and the
furthermost notches for slow speeds (work with the hook).
7. The grid must be down and the bowl in the raised position before starting the
appliance by putting the on/off switch (13) to position 1; the lamp should light up.
8. When the preparation is ready, stop the machine:
a. either by putting the On / Off switch (13) to the 0 position,
b. or by pressing the red "mushroom-head" switch (14).
9. Pull the handle (1) forwards to lower the bowl (2).
10. Then either remove the tool from the rotating shaft by unlocking the bayonet
system then remove the bowl (2), or remove the bowl (2) then remove the tool from
the rotating shaft by unlocking the bayonet system.
HOW TO STOP THE MACHINE
The machine can be stopped in several ways:
by using the On / Off switch (13),
or by pressing the red "mushroom-head" switch (14).
or by raising the safety grid (9),
or by unlocking the bowl (2)
ADDING INGREDIENTS DURING PROCESSING
You can add further ingredients (flour, eggs, oil, etc) during processing.
How to do this:
either through the safety grid (9) with the appliance running,
or by stopping the machine by raising the safety grid (9). To start the appliance up
again, the safety grid (9) must be lowered.
TAKE CARE: Scattering of flour dust when loading or starting the appliance is
dangerous for health. It is recommended to fill the bowl gradually (at an even rate),
and even to use a protective mask in reduce any inhalation of flour dust to a
minimum.
!
To Next Page
Loading...
